LumberJocks

All Replies on Need help on drawer design

  • Advertise with us
View Joel_B's profile

Need help on drawer design

by Joel_B
posted 07-31-2016 03:26 AM


5 replies so far

View MT_Stringer's profile

MT_Stringer

3183 posts in 3775 days


#1 posted 07-31-2016 06:55 AM

Yes. Cut the back short. Slide in the bottom and pin it.

-- Handcrafted by Mike Henderson - Channelview, Texas

View JBrow's profile

JBrow

1368 posts in 1464 days


#2 posted 08-01-2016 01:17 AM

Joel_B,

If you are crafting you own drawer slides, I would think a ¼” recess to the bottom edges of the sides would leave sufficient material to keep the bottom in place. However, if at some future point you decide to add manufactured drawer glides, a ½” bottom clearance is generally required for under mount slides.

I capture the drawer bottom in a groove all around the perimeter for the added continuous support. I figure if I ever had to replace the bottom of a drawer, I could rip the back of the drawer to install a new bottom. Nonetheless a back that is shorter than the front and sides should work fine, but the weak point is where the bottom is attached to the drawer box back. Since you are using screws and it is a nightstand where the contents of the drawers will weigh very little, I fail to see any problems. I have noticed drawers where the bottom is nailed to the back do not hold up very well.

View pintodeluxe's profile

pintodeluxe

6002 posts in 3357 days


#3 posted 08-01-2016 05:21 AM

1/2” is pretty standard, but plan everything around the drawer slides you plan to use.

-- Willie, Washington "If You Choose Not To Decide, You Still Have Made a Choice" - Rush

View Robert's profile

Robert

3558 posts in 2025 days


#4 posted 08-01-2016 12:09 PM

1/4” is pretty standard but keep in mind with plywood depending on the quality you may end up with it breaking off especially if your bottom is a little snug. You also see this frequently in mass produced drawers just from use and a couple drops on the floor.

Another option, perfectly acceptable, is to make a a groove out of 2 runners top and bottom of the drawers One is set, then the drawer is placed, then the other is glued on.

Yes, you cut the back short and slide the bottom in, use screws. I usually do this while the glue is still green helps square up the drawer.

Hope this helps. Good luck!

-- Everything is a prototype thats why its one of a kind!!

View Joel_B's profile

Joel_B

359 posts in 1925 days


#5 posted 08-02-2016 04:47 AM

I went with 3/8” from the bottom, turned out great.
Now just have to glue it up.

-- Joel, Encinitas, CA

Have your say...

You must be signed in to reply.

DISCLAIMER: Any posts on LJ are posted by individuals acting in their own right and do not necessarily reflect the views of LJ. LJ will not be held liable for the actions of any user.

Latest Projects | Latest Blog Entries | Latest Forum Topics

HomeRefurbers.com