LumberJocks

All Replies on Dovetails 1/4 or 1/2

  • Advertise with us
View jwmalone's profile

Dovetails 1/4 or 1/2

by jwmalone
posted 07-26-2016 06:58 PM


2 replies so far

View JBrow's profile

JBrow

1368 posts in 1277 days


#1 posted 07-31-2016 06:40 PM

jwmalone,

Once the drawers are assembly I doubt it makes much difference whether the dovetails are ½” or ¼”. There is a lot of glue surface and either joint should be very strong. There would be a greater number of ¼” dovetails than ½” dovetails, so the joint could look a little busy; but then appearance is a personal preference.

I would think a little more care would be needed during assembly if ¼” dovetails are selected. It will take longer to apply glue to the more numerous ¼” dovetails, so a glue with a long open time could be useful. Also, gluing just one joint at a time might be a good idea (which may also be good with ½” dovetails) especially if the glue begins to skim over. The smaller ¼” dovetail pins would be more susceptible to breaking if a mallet is used to drive the glue ladened joint together without a scrap board to support the pins when driving the joint home. But in the end, I think it is mostly a matter of personal preference; mine being ½” dovetails.

View jwmalone's profile

jwmalone

769 posts in 1060 days


#2 posted 07-31-2016 07:06 PM

Thanks Jbrow, Ive since decided to do them by hand. My jig is just to aggravating. Nothing wrong with it paid 15 dollars for never used still in the box

-- "Boy you could get more work done it you quit flapping your pie hole" Grandpa

Have your say...

You must be signed in to reply.

DISCLAIMER: Any posts on LJ are posted by individuals acting in their own right and do not necessarily reflect the views of LJ. LJ will not be held liable for the actions of any user.

Latest Projects | Latest Blog Entries | Latest Forum Topics

HomeRefurbers.com