All Replies on Dust Collection: If squished 4" wire hose to 1" oval, venturi effect?

  • Advertise with us
View Holbs's profile

Dust Collection: If squished 4" wire hose to 1" oval, venturi effect?

by Holbs
posted 12-20-2018 04:27 AM

4 replies so far

View SuperCubber's profile


1120 posts in 3086 days

#1 posted 12-20-2018 12:04 PM

That seems like a logical line of thinking, but as the air exits the Venturi, it will slow back down. I don’t see a big benefit.

-- Joe | Spartanburg, SC | "To give anything less than your best is to sacrafice the gift." - Steve Prefontaine

View EarlS's profile


3774 posts in 3149 days

#2 posted 12-20-2018 12:58 PM

Yes, the velocity will increase through the venturi, but it will result in a lower airflow at the mouth of the pipe where you want the highest air flow to pull the dust and chips into the hose. You would be better off to leave the 4” line the same size and not reduce it and make wide mouth inlet for the bottom of the bandsaw.

BTW – there was some discussion on the Spring Swap forum between Dave Polaschek and a couple other LJ’s about making DC adapters to use under the bandsaw table. I’ll post a note there to have him chime in here.

-- Earl "I'm a pessamist - generally that increases the chance that things will turn out better than expected"

View MikeDilday's profile


285 posts in 1260 days

#3 posted 12-20-2018 01:02 PM

If using a 6 to 4” wye gives you an extra 4” why didn’t you just use a 6-4 reducer and only have one 4” pipe?

-- Michael Dilday, Suffolk, Va.

View Holbs's profile


2349 posts in 2831 days

#4 posted 12-21-2018 02:25 AM

The measurements underneath the bandsaw table (clone bandsaw) is roughly 1 ” of space. That is my limiting factor. The venturi center point would actually be where the bandsaw blade is. But Earl says slow air flow from the get go due to the venturi anyways. Hmm…
Well…I’ll try it out anyways :) I just bought that router dust collector vinyl boot thingy (Milescraft Dust Router). Wonder if a 2nd one would work on a bandsaw.
Will be a busy weekend for installing and testing!
If all else fails, new DIY bandsaw table with dust collection chambers here I come! Even if it means losing 2-3” of resaw height (as if there is much to begin with on this 14”).

-- The Carpenter Bee is derived from the Ancient Greek word wood-cutter "xylokopos/ξυλοκὀπος"

Have your say...

You must be signed in to reply.

DISCLAIMER: Any posts on LJ are posted by individuals acting in their own right and do not necessarily reflect the views of LJ. LJ will not be held liable for the actions of any user.

Latest Projects | Latest Blog Entries | Latest Forum Topics