All Replies on Cutting 45 degree miter in counter top

  • Advertise with us
View dfox52's profile

Cutting 45 degree miter in counter top

by dfox52
posted 12-12-2018 04:38 PM

6 replies so far

View Bob5103's profile


150 posts in 1436 days

#1 posted 12-12-2018 05:43 PM

For me trying to cut a counter top to a “perfect” miter is one of the more miserable jobs in life. Having to deal with walls that are out of square, set up for the miter cut etc.. just makes me irritated. Creating a mason’s miter with a jig makes it easy. This is the one I use:
The jig even has the templates for cutting the recesses for the tite-joint fasteners.
It wont make an invisible joint but its not bad looking either. Here is a close up of one I did for our last house. The counter is 1 3/4” maple butcher block.

There are several online videos showing how to use the jig.

View TheFridge's profile


10859 posts in 2088 days

#2 posted 12-12-2018 05:47 PM

I’d probably cut one side with a reliable straightedge and skilsaw. scribe the other side and trim to fit.

-- Shooting down the walls of heartache. Bang bang. I am. The warrior.

View LesB's profile


2301 posts in 4045 days

#3 posted 12-12-2018 06:20 PM

That hardware will work to pull the joint tight and using biscuits or splines in the joint would help keep the two sections aligned.

I can think of several ways to work on this. Not knowing what tools you have or your skill level, laying out the lines for the cut and carefully cutting with a circular skill saw and a straight edge guide is the most basic. Remember the saw cuts upward and could splinter the top surface so make the cut from the bottom side and use the appropriate blade for smooth cuts. Any miss match of the two edges would have to be corrected with a hand plane.

-- Les B, Oregon

View Lee's profile


140 posts in 1480 days

#4 posted 12-12-2018 11:48 PM

The Fridge has the easiest way IMHO, it’s worked for me a few times with decent results. Cut a 45 in the end of one piece with straight edge, put tape down on the cut line and make a shallow scoring cut about 1/8” deep, then full cut. Then cut the other piece to fit square on both ends. put the first piece over the top of the second, pushing both pieces into the wall and the corner, put tape down on the second piece at the cut line, use the 45 on the first piece as a scribe and mark the second cut, do a shallow score cut, then full cut. now you have a perfect match for the probably out of square corner.

-- Colombia Custom Woodworking

View dfox52's profile


34 posts in 2296 days

#5 posted 12-13-2018 10:55 AM

Thanks everyone! Great ideas! I’ll post pictures when finished.

View maxyedor's profile


27 posts in 927 days

#6 posted 12-19-2018 10:58 PM

Grab a big, reasonably high quality speed square, and use that to set a fence or a DIY track for your circular saw, make the cuts. Once they’re cut, test-fit and if required, tune up the fit with either a block-plane or a sander, but the block plane will be far easier.

I’ve done a few this way and it’s really fast and really easy to get a perfect glue joint.

Have your say...

You must be signed in to reply.

DISCLAIMER: Any posts on LJ are posted by individuals acting in their own right and do not necessarily reflect the views of LJ. LJ will not be held liable for the actions of any user.

Latest Projects | Latest Blog Entries | Latest Forum Topics