LumberJocks

All Replies on Stopping the checking

  • Advertise with us
View Steve's profile

Stopping the checking

by Steve
posted 11-29-2018 03:36 PM


5 replies so far

View HokieKen's profile

HokieKen

8628 posts in 1436 days


#1 posted 11-29-2018 04:28 PM

Is the wood dry Steve? If it’s fairly well dried already, then chances are the checking is done. It probably occurred when the wood was green. Looks like the checking went pretty deep so I’m not sure if maple dust and CA would penetrate all the way down. I’d probably dye some epoxy and pour it in there if it were me. I think you’re probably just dealing with a design issue though rather than needing to stabilize it.

Just my $.02 of course! YMMV

-- Kenny, SW VA, Go Hokies!!!

View Steve's profile

Steve

1082 posts in 880 days


#2 posted 11-29-2018 04:37 PM

Thanks Kenny. I’m pretty sure it’s dry, although I haven’t checked it with my meter.

I thought it was an interesting shape, so i grabbed it. I’ll try the epoxy route.

View LesB's profile

LesB

2004 posts in 3740 days


#3 posted 11-29-2018 09:36 PM

My experience is that medium thick CA glue stays fluid long enough to penetrate those cracks without a problem and usually stops further cracking. If you want to fill them with fine saw dust first I suggest using a combination of thin CA glue first to soak into the dust and immediately follow it with the medium glue. The thin glue acts as a wicking agent to draw the thicker glue in. It would be much easier than messy epoxy.

Use caution and good ventelation with this because if there is any moisture in the cracks the CA may produce fumes (sometimes visible smoke like vapor) that you do not want to breath.

-- Les B, Oregon

View Steve's profile

Steve

1082 posts in 880 days


#4 posted 11-29-2018 09:45 PM

Just for reference, CA glue is the same thing as super glue right?

View DS's profile (online now)

DS

3082 posts in 2718 days


#5 posted 11-29-2018 09:55 PM

Cyanoacrylate = Super Glue = CA Glue

BTW, My usual method of stopping checking is to cut the checked end off of the work piece, build the project, then seal with sanding sealer. This, of course, assumes you allowed enough waste material to sacrifice a couple inches off of the ends of your checked boards.

-- "Hard work is not defined by the difficulty of the task as much as a person's desire to perform it.", DS251

Have your say...

You must be signed in to reply.

DISCLAIMER: Any posts on LJ are posted by individuals acting in their own right and do not necessarily reflect the views of LJ. LJ will not be held liable for the actions of any user.

Latest Projects | Latest Blog Entries | Latest Forum Topics

HomeRefurbers.com