LumberJocks

All Replies on Drawer face treatment

  • Advertise with us
View deadherring's profile

Drawer face treatment

by deadherring
posted 11-27-2018 04:17 AM


4 replies so far

View bilyo's profile

bilyo

565 posts in 1404 days


#1 posted 11-27-2018 03:47 PM

This is a question of aesthetics and, therefore, is a matter of opinion. Mine is that drawers (or anything else) under the table probably should not draw attention and should be of simple unobtrusive design. I think the choice of walnut would be perfect, but don’t go big with embellishment. Maple pulls would be as far as I would go. IMHO.
Nice work on the desk. Looks great.

View Bill_Steele's profile

Bill_Steele

486 posts in 2033 days


#2 posted 11-27-2018 04:07 PM

Nice job on this project—I think your floating desk great! What do you use to support the desk? I have a floating desk that I made out plywood and MDF (total thickness 1.5”) and I support it with a series of double slot shelf support brackets.

The high contrast in the color of the wood you chose is visually interesting and is really the “star of the show” here. I would probably tend to go with something simple (a single wood) for the drawer—like bilyo suggests. Don’t try to draw the attention away from top. I would also consider NOT adding drawers to the desk if the drawers will limit the range of motion where you can move your chair under the desk. Maybe a small rolling cabinet that has drawers if range of motion is limited by the drawers.

I added a wire chase/shelf below my desk where I run all my wires, surge protectors, sub-woofer, router, etc.)—it helps keep the desk surface a little clearer.

View deadherring's profile

deadherring

81 posts in 1945 days


#3 posted 11-27-2018 10:30 PM

Thanks guys.

@bilyo I used these brackets: https://ironsupports.com/collections/hidden-countertop-brackets/products/standard-front-mount-countertop-l-bracket

@Bill_Steele- I made a small box that is flush with the wall and faced with walnut to hide all the wiring.

20” for the large section and 12” for the short section.

Re: the drawers: the range of motion won’t be restricted. I will mount all the way to the right side, flush with the desk edge.

Now that I think about, i think you guys are right about not drawing attention away from the desk (both my wife and daughters said the same thing!). I will go with just walnut.

Do you think I should just do a regular edge—i.e no other treatment to the edge of the faces or route a profile of some kind?

Thanks!

Nathan

View bilyo's profile

bilyo

565 posts in 1404 days


#4 posted 11-27-2018 11:23 PM



Do you think I should just do a regular edge—i.e no other treatment to the edge of the faces or route a profile of some kind?

Your preference. Your desk edges look like a simple round over. You might consider being consistent with that.

Have your say...

You must be signed in to reply.

DISCLAIMER: Any posts on LJ are posted by individuals acting in their own right and do not necessarily reflect the views of LJ. LJ will not be held liable for the actions of any user.

Latest Projects | Latest Blog Entries | Latest Forum Topics

HomeRefurbers.com