LumberJocks

All Replies on Table saw platforms?

  • Advertise with us
View optimusprimer92's profile

Table saw platforms?

by optimusprimer92
posted 11-19-2018 05:02 PM


4 replies so far

View hkmiller's profile

hkmiller

124 posts in 380 days


#1 posted 11-19-2018 07:16 PM

A mobile base would give you some height

-- always something

View jonah's profile

jonah

2036 posts in 3597 days


#2 posted 11-19-2018 07:23 PM

It won’t give you 3” though. For that you’d have to either put a couple pieces of plywood down inside the mobile base for the saw base to sit on (and then you’d likely want to bolt it down to the wood), or just build a small platform out of plywood for the saw to sit on.

Personally, I need my saw to be mobile so I just adjusted my workbench height down an inch (mine was closer to 36” and my saw is 35” with the mobile base).

View MT_Stringer's profile

MT_Stringer

3183 posts in 3530 days


#3 posted 11-19-2018 07:43 PM

With my luck, I would trip on the platform while operating the saw and cause a bad accident.

-- Handcrafted by Mike Henderson - Channelview, Texas

View SASGeek's profile

SASGeek

8 posts in 140 days


#4 posted 11-19-2018 07:51 PM

I had the same issue with my UniSaw I simply made a base out of MDF traced the base on the platform. I removed the base and cut it along the lines that I had put on it, using a jig saw and replacing it beneath the saw. It worked fine and continues to hold my saw at the correct height. It has been almost 10 years.

I hope that this helps.

Dick

-- Dick Shryock, on the rock bound coast of Maine

Have your say...

You must be signed in to reply.

DISCLAIMER: Any posts on LJ are posted by individuals acting in their own right and do not necessarily reflect the views of LJ. LJ will not be held liable for the actions of any user.

Latest Projects | Latest Blog Entries | Latest Forum Topics

HomeRefurbers.com