All Replies on Determining mortise depth

  • Advertise with us
View groland's profile

Determining mortise depth

by groland
posted 10-28-2018 02:52 AM

6 replies so far

View lumbering_on's profile


578 posts in 1339 days

#1 posted 10-28-2018 03:12 AM


I usually use a haunched m&t as it gives better gluing surface, and provides excellent support. However, I’ve never had them meet.

View TheFridge's profile


10861 posts in 2335 days

#2 posted 10-28-2018 03:23 AM

I don’t let them meet but I alway make them as long as possible.

-- Shooting down the walls of heartache. Bang bang. I am. The warrior.

View Rich's profile


5870 posts in 1438 days

#3 posted 10-28-2018 03:37 AM

You can always miter the ends of the tenons to get maximum length. However, unless your legs are very thin, I wouldn’t worry about it.

-- Half of what we read or hear about finishing is right. We just don’t know which half! — Bob Flexner

View MrRon's profile


5931 posts in 4092 days

#4 posted 10-28-2018 03:59 PM

Here are 3 possible M&T joints that can be made. In these examples, the legs are 2”x2” and the tenoned pieces are 3/4” stock. The tenons are the normal relationship of a 3/8” tenon on 3/4” stock.
The left hand sketch is where the mortises intersect.
The middle sketch shows where the tenons are mitered.
The right hand sketch shows where the tenons have been shifted to the far face of the wood. This allows for more “meat” in the leg. Naturally, if design permits, the pieces can be offset giving more strength to the joint.

View ocean's profile


212 posts in 1682 days

#5 posted 10-28-2018 05:33 PM

I’ve always made my mortises in a leg met. I also have almost always had small legs, so I was trying to get max glue surface. As Ron shows in drawing #2. So far never had any problem with joint failure.

-- Bob, FL Keys

View John_'s profile


251 posts in 2555 days

#6 posted 10-29-2018 05:06 AM

I recently found myself in a similar situation and ended up using an ‘interlocking tenon’. Here is a pic of some scrap pieces I used for practice

Have your say...

You must be signed in to reply.

DISCLAIMER: Any posts on LJ are posted by individuals acting in their own right and do not necessarily reflect the views of LJ. LJ will not be held liable for the actions of any user.

Latest Projects | Latest Blog Entries | Latest Forum Topics