LumberJocks

All Replies on Putting Lid on Box Joint Box

  • Advertise with us
View Jim Ganley's profile

Putting Lid on Box Joint Box

by Jim Ganley
posted 10-16-2018 03:16 PM


4 replies so far

View bondogaposis's profile

bondogaposis

5573 posts in 2917 days


#1 posted 10-16-2018 04:00 PM

You can glue the box together first then use a rabbit bit on the router table to make the recess for the top and bottom. I’ve done this many times.

-- Bondo Gaposis

View Rich's profile (online now)

Rich

5011 posts in 1156 days


#2 posted 10-16-2018 04:19 PM

If I understand what you are trying to do correctly, I was dealing with the same issue making some small lidded boxes. What I wound up doing was gluing up the box, sawing off the lid, and then lining it with very thin maple. It not only provided a nice contrast in color, but finished off the interior of the box. I also glued down a piece to the bottom interior. By leaving the lining about 1/4 to 5/16 inch above the edge of the box and rounding over the lip, it aligned the lid.

-- Half of what we read or hear about finishing is right. We just don’t know which half! — Bob Flexner

View Peteybadboy's profile

Peteybadboy

1358 posts in 2516 days


#3 posted 10-16-2018 04:37 PM

I take a board and just glue it to the box sides (like rich above) (not the index lining part which is cool) , but just glue a board on top and plane/sand it to flush to the lid.

-- Petey

View Jim Ganley's profile

Jim Ganley

54 posts in 3734 days


#4 posted 10-18-2018 03:58 PM

Thanks guy’s going to make it much more workable and fun I really hate it when I hit a stumper, using the router will that leave round corners or would I have to stop before the corners and chisel the corners square. Another problem I have with the box joints is how do I get them square? once all the clamps are on it is almost impossible to get any type of reading. I glued one up last night and this morning it is out of square, side A-C is 11- 3/8” and sides B-D is 11 -7/16 those stick outs are a problem and would be much easier if I could remove them ahead of time.

-- Jim - Cushing, WI

Have your say...

You must be signed in to reply.

DISCLAIMER: Any posts on LJ are posted by individuals acting in their own right and do not necessarily reflect the views of LJ. LJ will not be held liable for the actions of any user.

Latest Projects | Latest Blog Entries | Latest Forum Topics

HomeRefurbers.com