LumberJocks

All Replies on Crevasses/gaps in polyurethane table top

  • Advertise with us
View Schnurrwood's profile

Crevasses/gaps in polyurethane table top

by Schnurrwood
posted 10-09-2018 12:16 AM


2 replies so far

View squazo's profile

squazo

124 posts in 2040 days


#1 posted 10-09-2018 01:33 AM

I would think thinning it would just make it take more coats to fill it in. Id say just keep going un thinned and sand it flat eventually.

View Sark's profile

Sark

102 posts in 755 days


#2 posted 10-23-2018 07:10 PM

I’ve had bad luck with too many coats of polyurethane, mainly because I did not allow enough time between recoating. Hopefully you did, because if you didn’t allow enough time, the poly may still be soft and gummy inside though dry to the fingers. If you wiped on and wiped off the finish, it may be that the finish is quite dry all the way through since wiping finishes go on thin. Spray finishes are somewhere in between. Did you sand between each of these coats? If so, then your finish is probably dry all the way through.

I wouldn’t add more coats without sanding it down. It’s quite possible to fill cracks with finish alone, and this is the historic way of doing it with shellac/pumice and rottenstone. Paste wood fillers definitely speed things up if the cracks are big. But the process is the same. Fill, sand, coat, finish, sand, fill, finish, sand…etc until all the voids are filled and the top looks the way you want.

Have your say...

You must be signed in to reply.

DISCLAIMER: Any posts on LJ are posted by individuals acting in their own right and do not necessarily reflect the views of LJ. LJ will not be held liable for the actions of any user.

Latest Projects | Latest Blog Entries | Latest Forum Topics

HomeRefurbers.com