All Replies on Double Sided V-Groove Router Bit?

  • Advertise with us
View pf_flyguy's profile

Double Sided V-Groove Router Bit?

by pf_flyguy
posted 10-04-2018 10:48 PM

4 replies so far

View Shamb3's profile


39 posts in 749 days

#1 posted 10-04-2018 11:40 PM

Why do those not work?
The tongue is 1/4 inch. So wouldn’t you just adjust that part to be 1/8th of an inch above the table? Then flip the boards as you described?

View gwilki's profile


329 posts in 2041 days

#2 posted 10-05-2018 12:57 AM

I’m with Shamb3. I have that same set from Lee Valley and I’ve made miles of tongue and groove with it. What part of it does not work for you?

-- Grant Wilkinson, Ottawa ON

View 000's profile


2859 posts in 1467 days

#3 posted 10-05-2018 01:18 AM

The problem is the 1/2” material.
The tongue is 1/4” then there is a lip that looks to be 1/16 (or bigger). This doesn’t leave much for the bevel
You need a set up without the lip, since your using a Yonico bit look at this one for comparison.
(you would have to set up a fence for to cut the tongue because there is no bearing)

Why are you using 1/2” material? I would think 3/4” min.?

View pf_flyguy's profile


2 posts in 2682 days

#4 posted 10-05-2018 01:28 AM

evidently, Yonico have a “Small” V-groove set also. the tongue is 3/8 on this one

I will give this set a shot and see if I get better results

Have your say...

You must be signed in to reply.

DISCLAIMER: Any posts on LJ are posted by individuals acting in their own right and do not necessarily reflect the views of LJ. LJ will not be held liable for the actions of any user.

Latest Projects | Latest Blog Entries | Latest Forum Topics