All Replies on Comments on Makita track saw?

  • Advertise with us
View Tedstor's profile

Comments on Makita track saw?

by Tedstor
posted 10-04-2018 05:03 PM

7 replies so far

View duc996's profile


32 posts in 2351 days

#1 posted 10-04-2018 06:29 PM

Tedstor, I have been using the Makita cordless 36 volt track saw for breaking down sheet goods and it has been a very good saw. I have owned both Festool TS55 and TS75 and I have sold them both because for what I do the Makita fits me better. The Makita is lighter compared to the Festool I had owned. I went cordless because I usually break down 4×8 sheet goods in my driveway. I also purchased the mafell dust bag to catch all the saw dust and the bag works great. Another thing to note is that the Makita blades are really thin kerf thus making cuts seem effortlessly on 3/4” stock. If you cut thicker stock just go slower. I also use my Makita track saw on the Festool guide rails as well. Hope that helps.

View edapp's profile


342 posts in 2284 days

#2 posted 10-04-2018 06:55 PM

I really like my Makita track saw. Bargain compared to the Festool…. but still too expensive for what it is IMO.

It is extremely helpful, and I find uses for it all the time when drawing layouts and cutting angles that would either take setup time on the tablesaw or be too big for my shop. You wont regret getting it!

View Andre's profile (online now)


3702 posts in 2660 days

#3 posted 10-04-2018 07:30 PM

Looked at and like the Makita but while shopping for one came across a Dewalt that included the long trac on sale!
Don’t use the long track often but sure is nice when I do! By the way Dewalt works flawlessly, but now probably would get the cordless saw!

-- Lifting one end of the plank.

View Jared_S's profile


399 posts in 813 days

#4 posted 10-04-2018 08:10 PM

It’s a fantastic saw.

View BigMig's profile


487 posts in 3467 days

#5 posted 10-04-2018 10:29 PM

I only used a borrowed Festool and it was nice, but I’ll never spring for one. A makita, maybe, depending on what I read here.

-- Mike from Lansdowne, PA

View Firewood's profile


1302 posts in 2488 days

#6 posted 10-04-2018 11:37 PM

I have the Makita for breaking down sheet goods (I have a basement shop and hard to get full sheets down there). It works absolutely wonderful. The cuts are extremely smooth. I don’t use too often, but it is a pleasure to use when it is needed.

-- Mike - Waukesha, WI

View ArtMann's profile


1480 posts in 1670 days

#7 posted 10-05-2018 12:11 AM

I use mine all the time. I just regret that I didn’t get one sooner. It just solves so many problem cuts and the cut quality is as good as my table saw. I highly recommend this tool.

Have your say...

You must be signed in to reply.

DISCLAIMER: Any posts on LJ are posted by individuals acting in their own right and do not necessarily reflect the views of LJ. LJ will not be held liable for the actions of any user.

Latest Projects | Latest Blog Entries | Latest Forum Topics