All Replies on How to remove slop from back side of Craftsman Exact-i-rip fence?

  • Advertise with us
View 1tacoshort's profile

How to remove slop from back side of Craftsman Exact-i-rip fence?

by 1tacoshort
posted 09-23-2018 12:18 AM

6 replies so far

View Holt's profile


280 posts in 3109 days

#1 posted 09-27-2018 03:41 PM

I have that fence and do the same song and dance. I haven’t found a great way to adjust that fence to help the back lock in the proper position. If you are doing a lot of the same wide rip, you can build a spacer out of plywood or MDF with a runner near one edge that rides in the miter gauge slot, kind of like a cross cut sled. If you have an Incra miter gauge, you can set and lock it and use it to check the fence all along the miter slot…

-- ...Specialization is for insects.

View Madmark2's profile


485 posts in 1068 days

#2 posted 09-27-2018 04:06 PM

You solve this problem with your bank card. is the best fence and will raise your skills a full level.

Take it from someone that has been there.


View Bill Berklich's profile

Bill Berklich

890 posts in 868 days

#3 posted 09-27-2018 05:47 PM

I have a 2424 Exact-i-Rip. It’s a”T” style so if it’s not locked down the whole thing floats. The fence registers off the inside face of the front “T”. To make sure the back matches the front you need to apply some pressure on the front and force the “T” to register against the front edge of the fence glide rail.

I assume that the actual problem is that you get it set up and the fence jumps when you lock it down. A problem with these fences are that the inside face of the “T” has (had) a couple of pieces of polyethylene tape which eventually falls off/folds/bunches. Get some .01” replacement HDPE or HMWPE tape. Also when you move your fence move the whole fence don’t just drag it by the handle. And of course make sure your glide track is clean front and back.

Oh in case you haven’t, check that the fence is perpendicular to the “T” head. The easiest ways I’ve found is to clamp the Fence vertically then use a Wixey. Zero it on the Fence than set it on the “T” head face. Loosen the bolts and adjust it to 90 degrees.

Or like the man says open your wallet…

-- Bill - Rochester MI

View RDan's profile


108 posts in 2804 days

#4 posted 09-29-2018 03:13 AM

I had the same issue with this fence. It was the replacement fence for my original C-Man fence. I used the same method with a large speed square. I wish I had a different one. I now have a Sawstop with the T-Glide, what a difference. Locks in with 1/16” accuracy. Dan

View 1tacoshort's profile


45 posts in 1358 days

#5 posted 09-29-2018 04:46 AM

Thanks guys!

-- Wade

View Charlie H.'s profile

Charlie H.

385 posts in 1130 days

#6 posted 09-30-2018 04:02 PM

Have your say...

You must be signed in to reply.

DISCLAIMER: Any posts on LJ are posted by individuals acting in their own right and do not necessarily reflect the views of LJ. LJ will not be held liable for the actions of any user.

Latest Projects | Latest Blog Entries | Latest Forum Topics