All Replies on Tablesaw dilema

  • Advertise with us
View HHammer's profile

Tablesaw dilema

by HHammer
posted 09-21-2018 02:07 AM

1 reply so far

View EdDantes's profile


74 posts in 712 days

#1 posted 09-21-2018 08:27 PM

A new aftermarket fence for the Delta is going to run you $200-$400 depending on what you buy. But you could get a Delta T2 for a little over $200 and then you’d have a nice setup for around $300. I can’t comment on a Bies-style vs. Unifence, but it seems it’s personal preference from historical posts. If you found a cheap, used unifence and cost was a factor it might be the way to go. Whatever you’d decide for the fence, I’d still consider that a significant upgrade over the jobsite saw even if you built a saw station for it.

Have your say...

You must be signed in to reply.

DISCLAIMER: Any posts on LJ are posted by individuals acting in their own right and do not necessarily reflect the views of LJ. LJ will not be held liable for the actions of any user.

Latest Projects | Latest Blog Entries | Latest Forum Topics