3 replies so far
#1 posted 09-18-2018 03:01 PM |
It could work, but the holes may not line up. That’s not a huge issue, however, since cast iron is quite easy to drill holes in. Just drill some new holes and bolt it on. You’d be better off if you have a pretty beefy fence/rail combination, since the angle steel from the fence rails will help hold everything together. If you have the OEM fence, you might end up with a lot of sag. |
#2 posted 09-18-2018 05:36 PM |
That should work. I have purchased a few extension wings off of ebay, you just have to get lucky and find solid ones that don’t cost a fortune. I got lucky once and scored two wings for about $30 and then $50 for shipping. -- Two thumbs and counting |
#3 posted 09-18-2018 11:09 PM |
Have you thought about installing a cast iron wing with a router table cut out like the benchdog or MLCS? It’s a pricey upgrade, but a good one if you have limited space. I was lucky with my 315 saw it had a solid cast iron wing on one side with a router mount and a stamped wing on the other that I replaced with the Benchdog, I now have 2 routers mounted on my saw. I’ve also seen where people filled in the webs of the standard CI wing with wood. |
Have your say...
You must be signed in to reply.
|