LumberJocks

All Replies on Found out, I have the infamous concave miter saw table.

  • Advertise with us
View Holbs's profile

Found out, I have the infamous concave miter saw table.

by Holbs
posted 02-12-2018 04:35 AM


3 replies so far

View Rich's profile

Rich

4156 posts in 891 days


#1 posted 02-12-2018 05:21 AM

Sounds tricky. I’d be more inclined to go at it with some sandpaper glued to a piece of 3/4” MDF. Nice and flat, and you can use Scotch 77 or something like that to attach the sandpaper without any bulges.

-- Half of what we read or hear about finishing is right. We just don’t know which half! — Bob Flexner

View Holbs's profile

Holbs

2176 posts in 2331 days


#2 posted 02-12-2018 05:30 AM

I stand corrected. I went further down the rabbit hole with dial caliper and height gauge. The circular rotating table top is actually not too bad and acceptable (less than 0.01”) so while it is slightly concave, it’s good enough for wood working purposes. However, the entire top is higher than the infeed/outfeed support by 0.035”. This is the problem because this explains why short (less than 6” long) pieces come out square but long pieces come out of square due to the raising of the angle at the blade.

For temp purposes, probably will go layering paper on the infeed/outfeed tables to make things coplanar. In due time, I might disassemble and find out what I can shave off some 0.035” somewhere under the rotating table.

-- The Carpenter Bee is derived from the Ancient Greek word wood-cutter "xylokopos/ξυλοκὀπος"

View woodbutcherbynight's profile

woodbutcherbynight

5938 posts in 2711 days


#3 posted 02-12-2018 05:33 AM

Have your say...

You must be signed in to reply.

DISCLAIMER: Any posts on LJ are posted by individuals acting in their own right and do not necessarily reflect the views of LJ. LJ will not be held liable for the actions of any user.

Latest Projects | Latest Blog Entries | Latest Forum Topics

HomeRefurbers.com