LumberJocks

All Replies on Low angle light

  • Advertise with us
View DaveV's profile

Low angle light

by DaveV
posted 02-06-2018 04:54 AM


5 replies so far

View Rich's profile

Rich

5001 posts in 1129 days


#1 posted 02-06-2018 05:35 AM

Hard to be specific about it. Low enough to get a clean reflection off the surface. You’ll know when you get it right.

View Woodknack's profile

Woodknack

12927 posts in 2920 days


#2 posted 02-06-2018 07:08 AM

Kidding aside, the low angle is to produce shadows in the imperfections making them easier to see. A handheld light is easiest since you can change the angle up and down and left and right to get the best view depending on ambient light.

-- Rick M, http://thewoodknack.blogspot.com/

View oldnovice's profile

oldnovice

7505 posts in 3908 days


#3 posted 02-06-2018 08:02 AM

You can also use trace coatings as shown by Charles Neil’s video.

-- "I never met a board I didn't like!"

View Breeze73's profile

Breeze73

102 posts in 1221 days


#4 posted 02-06-2018 09:33 AM

This is typically called a Raking Light. If you have a workbench, you can fabricate an adjustable arm worklamp to fit the dog holes on your bench. This works very well, and it also helps to have the direct light available when doing fine chisel work too. Here is a method to convert a standard base lamp to a 3/4” dog hole.

http://madebyjohn.blogspot.com/2011/11/desk-light-for-workbench.html

-- Breeze

View OSU55's profile

OSU55

2443 posts in 2530 days


#5 posted 02-06-2018 01:24 PM

Get a flashlight and play around holding it across a surface from you, at various angles. The glossier a surface is the better it works. For a sanded surface try it dry then wet it down with ms.

Have your say...

You must be signed in to reply.

DISCLAIMER: Any posts on LJ are posted by individuals acting in their own right and do not necessarily reflect the views of LJ. LJ will not be held liable for the actions of any user.

Latest Projects | Latest Blog Entries | Latest Forum Topics

HomeRefurbers.com