• Advertise with us
View skidiot's profile


by skidiot
posted 02-04-2018 01:26 AM

6 replies so far

View WhyMe's profile


1320 posts in 2449 days

#1 posted 02-04-2018 02:27 AM

You need to make sure the mating surfaces are absolutely clean and torque the screws to the correct tightness.

View Fred Hargis's profile

Fred Hargis

6517 posts in 3382 days

#2 posted 02-04-2018 12:08 PM

Yep, the cleaning of the seats and the torque (45 in. lbs. for mine) is important. For me, even after I did that I still get light lines, they come off with 2 passe (literally) of the ROS. Funny thing, I did this (cleaning/torque) on the jointer and eliminated the lines, but it didn’t work that way on the planer, it leaves those little ridges. Bummer, since it sees the wood last.

-- Our village hasn't lost it's idiot, he was elected to congress.

View Tennessee's profile


2901 posts in 3403 days

#3 posted 02-04-2018 01:40 PM

Mine also has very, very light lines that can be removed with an ROS in about two passes. Started when I went to the second edge a couple years ago.
I was very careful to clean and blow out every bit of dust and contamination, and clean the back of the cutter before re-seating the cutter. Torque was done by me, but I must admit, taking them off, the tightness was all over the place.

It’s not a big deal considering I put some cherry burl, quilted and flamed through the planer a few days ago to make a wooden pickguard, running it down to 7MM thick, and I got zero tearout…

-- Tsunami Guitars and Custom Woodworking, Cleveland, TN

View robscastle's profile


7452 posts in 3093 days

#4 posted 08-27-2018 08:44 AM


-- Regards Rob

View Robert's profile


4065 posts in 2369 days

#5 posted 08-27-2018 04:05 PM

You need to make sure the mating surfaces are absolutely clean and torque the screws to the correct tightness.

- WhyMe


-- Everything is a prototype thats why its one of a kind!!

View BroncoBrian's profile


894 posts in 2847 days

#6 posted 08-27-2018 10:25 PM

If the cutters are flying around your shop, you might want to tighten them a bit more.

I would clean the head with compressed air BEFORE removing the blades. That way you are not knocking as much junk into them.

-- A severed foot is the ultimate stocking stuffer.

Have your say...

You must be signed in to reply.

DISCLAIMER: Any posts on LJ are posted by individuals acting in their own right and do not necessarily reflect the views of LJ. LJ will not be held liable for the actions of any user.

Latest Projects | Latest Blog Entries | Latest Forum Topics