All Replies on How shallow is too shallow.

  • Advertise with us
View Carloz's profile

How shallow is too shallow.

by Carloz
posted 01-14-2018 05:39 PM

6 replies so far

View Luthierman's profile


225 posts in 1975 days

#1 posted 01-14-2018 06:50 PM

In the cabinet shop we usually only do two passes. Granted, it is on a 7hp 1500lb machine. No vibration. I also don’t do any pre-cut with the table saw. I can see doing that on a smaller setup as being scary though. Doing what you are doing may not be necessary, but if it works for you and yields good results, I don’t see a problem. If something feels unsafe, chances are, it IS unsafe. Do what makes you feel comfortable.

Do you use any feather boards?

-- Jesse, West Lafayette, Indiana

View mikeber's profile


40 posts in 1747 days

#2 posted 01-15-2018 03:35 AM

Maple is hard, and being cautious smart, but that sounds like too many passes.
First question: did you match the router speed to that humangus cutter? What router are you using?

View Carloz's profile


1147 posts in 1479 days

#3 posted 01-15-2018 04:00 AM

Yes I dialed it down to the lowest setting. The router is 2.3 HP Bosch.
Maybe everything is cool but zi am too chicken to press it harder

View SweetTea's profile


478 posts in 1547 days

#4 posted 01-15-2018 11:11 AM

I have a 3HP Grizzly G1026 shaper that I use solely for making raised panels, and even with it being 3HP I can’t even hog off that much in one pass on a maple raised panel. I would normally do it in 4-6 passes with maple if feeding by hand. I have a skimpy 1/4HP Grizzly power feeder and with it I can do it with 3 passes on a good day. My next upgrade will definitely be bigger power feeders.

View Dustin's profile


707 posts in 1628 days

#5 posted 01-15-2018 12:33 PM

I think this is a scenario in which you have to weigh efficiency vs safety/security. One oft overlooked aspect of the former is that how safe you feel in any given operation is also of utmost importance (if for no other reason than that it effects your ability to enjoy woodworking). Personally, I’d rather save getting my heart racing for exercise, and take it slow with my machines. If I perform an operation in my shop which makes me breath a sigh of relief afterwards, I need to reevaluate my process.

-- "Ladies, if your husband says he'll get to it, he'll get to it. No need to remind him about it every 6 months."

View Craftsman on the lake's profile

Craftsman on the lake

3530 posts in 4325 days

#6 posted 01-15-2018 01:36 PM

I have a 3 1/4 hp triton in a a router table. I have frued raised panel bits of the same size you do. I usually need to make 4-5 passes. No table saw cuts. No vibration. Stupid question here. Of course you’re using these bits in a router table right?

-- The smell of wood, coffee in the cup, the wife let's me do my thing, the lake is peaceful.

Have your say...

You must be signed in to reply.

DISCLAIMER: Any posts on LJ are posted by individuals acting in their own right and do not necessarily reflect the views of LJ. LJ will not be held liable for the actions of any user.

Latest Projects | Latest Blog Entries | Latest Forum Topics