LumberJocks

All Replies on 1/2" spindles and thier limitations

  • Advertise with us
View indyj's profile

1/2" spindles and thier limitations

by indyj
posted 01-14-2018 01:35 AM


3 replies so far

View cabmaker's profile

cabmaker

1745 posts in 3348 days


#1 posted 01-14-2018 11:29 AM

The split fence does not neccesarily dictate the diameter capacity of you r machine , but it is something to pay attention to.

What you will find more critical is the table opening which sorta tells you, hey don’t put anything larger than this on this spindle,,,,,but i have in the past exceeded this by resorting to running face up.

Also the table opening is somewhat commensurate with spindle diameter and under nut capacity

On your spindle question…...3/4 inch is an ideal size on the 3 hp shapers…..and grizzly 3hp will allow up to a one inch,,,,,but not a 1 1/4.

Back to your first question…..on your craftsman shaper you will have several limitations…..mainly power to achieve proper performance with anything larger than the orig 1/2 inch spindle, table size, poor fence arrangement and a few other things. On the plus side you probably won’t be able to stack up anything on it that will get you into trouble.

If you are new to shaper operation, .......instead of worrying much about the concerns you posted i would be looking at putting power feeders on those machines. Although there will be more safety issues without feeders i think it is beneficial to have experience running these machines for a while without feeders to gain a good understanding of all the forces at work. With featherboards of coarse,,,,,,,and not the rinky dink plastic magnetic ones ! If you give me a pm will send you pics of what i would recommend.

JB

View runswithscissors's profile

runswithscissors

3081 posts in 2564 days


#2 posted 01-15-2018 12:38 AM

Those little shapers also have a very limited vertical adjustment range—less than an inch, on the ones I’m familiar with.

-- I admit to being an adrenaline junky; fortunately, I'm very easily frightened

View TungOil's profile

TungOil

1343 posts in 1034 days


#3 posted 01-15-2018 01:14 AM

I had one of those 1/2” spindle Craftsman shapers for many years. It’s fine for light duty shaping up to raised panel doors. I used 3/4” bore cutters bushed down to 1/2” and it worked fine. Mine had the waffle grid open top which I really disliked. It’s underpowered so you will need to feed slowly.

I eventually got rid of mine and picked up a used Powermatic, primarily so I could add a power feeder. As cabmaker pointed out, the feeder really makes a big difference both for safety as well as cut quality.

-- The optimist says "the glass is half full". The pessimist says "the glass is half empty". The engineer says "the glass is twice as big as it needs to be"

Have your say...

You must be signed in to reply.

DISCLAIMER: Any posts on LJ are posted by individuals acting in their own right and do not necessarily reflect the views of LJ. LJ will not be held liable for the actions of any user.

Latest Projects | Latest Blog Entries | Latest Forum Topics

HomeRefurbers.com