Reply by tom in indy

  • Advertise with us

Posted on New Grizzly Hybrid Table Saw

View tom in indy's profile

tom in indy

41 posts in 2985 days

#1 posted 12-30-2014 08:52 PM

paxorion thanks for the “hints”. I did get it figured out.
I was looking at the owners manual pages 61&62 about miter slot to blade adjustment. The trunnions are table mounted like a Contractor saw and the G0715P.
Below is an excerpt from the Owners Manual.

7. To adjust table, loosen two hex nuts that
secure rear trunnion (see Figure 118) to
underside of table 1–11⁄2 turns and slightly
tap trunnion with a rubber dead blow hammer
in needed direction.

DISCLAIMER: Any posts on LJ are posted by individuals acting in their own right and do not necessarily reflect the views of LJ. LJ will not be held liable for the actions of any user.

Latest Projects | Latest Blog Entries | Latest Forum Topics