LumberJocks

Reply by Graham

  • Advertise with us

Posted on Expectations for Table Saw Crosscut Accuracy...

View Graham's profile

Graham

19 posts in 3943 days


#1 posted 04-28-2009 05:05 AM

Thanks PurpLev and Topa. That helps me start to establish a tolerance reference. I was able to get the blade runout down to less than 1/4 of a thousandths, which is about down to the noise in the indicator.

After reading my initial post I don’t think I was clear.

All of the pieces cut to the exact same length were dead nuts on relative to each other, but the absolute length was off by 0.000” to 0.005”. So it is extremely repeatable, but not completely on in absolute terms.

Tomorrow my Oneida Dust collector arrives, so I am pretty excited about that. On Friday my Incra TS-LS table fence arrives.

Be well,
Graham


DISCLAIMER: Any posts on LJ are posted by individuals acting in their own right and do not necessarily reflect the views of LJ. LJ will not be held liable for the actions of any user.

Latest Projects | Latest Blog Entries | Latest Forum Topics

HomeRefurbers.com