Reply by PurpLev

what kind of router bit do I run on the table saw? flush trim bits… and roundover… doesn’t everyone? lol

how did you get to the conclusion I’m running router bits on the table saw? read my post again – bit spinning = router bit, blade cover = table saw BLADE

I’m quoting the OP (from his replied posts):

To me, this actually seems less dangerous than ripping on the table saw with a fence…

The traditional way is to joint one side then rip the other parallel on the table saw, correct? My table saw kind of sucks so I was looking for a way to do it on my router table…

This is where the Table saw came into the question.

-- ㊍ When in doubt - There is no doubt - Go the safer route.