Reply by BArnold

  • Advertise with us

Posted on Grizzly ZCI for G0691 Table Saw

View BArnold's profile


175 posts in 2919 days

#1 posted 09-15-2013 08:12 PM

Well, it’s probably too late to get a swap for it, but it’s worth a call or email to Grizzly to find out.

I make my own inserts with 1/2” mdf and I’ve noticed that the insert will lift a little if I raise the blade all the way, but I don’t normally run it that high, of course. To make the cut through it, I hold a new insert down and raise the blade through it. I then line up the insert over a 1/8” bit in my router table to run the slot farther back for the riving knife. Sounds like my next step needs to be making a pattern to rout a notch to provide clearance for the riving knife base.

-- Bill, Thomasville, GA

DISCLAIMER: Any posts on LJ are posted by individuals acting in their own right and do not necessarily reflect the views of LJ. LJ will not be held liable for the actions of any user.

Latest Projects | Latest Blog Entries | Latest Forum Topics