LumberJocks

Reply by Jared_S

  • Advertise with us

Posted on Baileigh JP-1686 Three Phase Electrical Question

View Jared_S's profile

Jared_S

489 posts in 1290 days


#1 posted 10-20-2021 03:24 PM



Not sure a VFD will be an easy implementation?

1) Thought the Baileigh JP-1686 used a 5.5HP (4.1KW) motor? A 3HP 12A may not be enough.

2) Looking at the manual, there is a lot of extra safety switches and controls in that control cabinet as part of the jointer/planer switch over. VFD needs to be hard wired to the motor, and can t have switches that interrupt current flow. Will need to remove the control cabinet wiring, and rewire the setup/safety switches to control the VFD, or the VFD will expel the dreaded magic smoke and stop working.

If you go VFD route, don t rely on catalog VFD ratings. Some 3HP VFD are 10A, while others are 12A. They also have to be de-rated based on ambient temp, and cheapest units have largest de-rating factors, some starting as low as 35°C.

Best Luck.

- CaptainKlutz

Didn’t realize that model had a powered table. Looking at it in more detail I’d agree with your assessment on the difficulty of integrating a vfd. Certainly possible but will require a good bit more work than a rpc.


DISCLAIMER: Any posts on LJ are posted by individuals acting in their own right and do not necessarily reflect the views of LJ. LJ will not be held liable for the actions of any user.

Latest Projects | Latest Blog Entries | Latest Forum Topics

HomeRefurbers.com