LumberJocks

Reply by DonS1959

  • Advertise with us

Posted on Chainsaw milling- Advise on Board slicing what best and is my process correct

View DonS1959's profile

DonS1959

38 posts in 125 days


#1 posted 04-19-2021 06:02 AM

@azwoodworker are you using a Alaskan sawmill to do your milling or what

the reason I asked is my wife and I lived off grid in North Eastern Arizona and her and I would go out to and area and spend a couple of days milling Alligator Juniper i made a few tables with the milled boards and then we would sell the tables I still have a couple that we made because my wife would not allow me to sell the two I kept we used a Alaskan sawmill and a Stihl 044 with a 24 inch bar to do the milling it was tough work and slow but where we would cut the wood was vary remote and extremely hard to get heavier equipment into the area


DISCLAIMER: Any posts on LJ are posted by individuals acting in their own right and do not necessarily reflect the views of LJ. LJ will not be held liable for the actions of any user.

Latest Projects | Latest Blog Entries | Latest Forum Topics

HomeRefurbers.com