Reply by CWWoodworking

  • Advertise with us

Posted on Crosscut with miter saw vs table saw

View CWWoodworking's profile


1759 posts in 1262 days

#1 posted 03-07-2021 01:48 AM

The only time I had a real problem with accuracy on my cheap sliders was with large 8/4 boards. I usually rough cut, ripped them down, and recut.

My biggest complaint was with durability. I’m not for sure if I’m cursed or I just used them that much. 2 different saws crapped out in 4 years.

My new delta is perfect across 12”. I measured and used every square/method I can think off when setting it up. I couldn’t cut it better with a table saw.

Just hope it holds up.

DISCLAIMER: Any posts on LJ are posted by individuals acting in their own right and do not necessarily reflect the views of LJ. LJ will not be held liable for the actions of any user.

Latest Projects | Latest Blog Entries | Latest Forum Topics