LumberJocks

Reply by controlfreak

  • Advertise with us

Posted on Craftsman 113 Jointer

View controlfreak's profile

controlfreak

3046 posts in 882 days


#1 posted 04-23-2020 04:49 PM

@AJ2 I had a heck of a time setting the knife height. I was trying the method where you measure how far you can “pull” a straight edge by hand turning the cutter wheel. Having three knives and adjustable outfeed would only add a fourth thing to screw up for me. Using the 123 block and dial gauge I was able to set the blades dead even with the outfeed table and get flat boards. The only way I can tune the infeed table is to buy a straight edge that would cost about half of what I paid for the jointer. As you said, it sounds like a pain to do so if I start getting poor quality due to infeed table I may just sell it and trade up. It will get me by until it doesn’t for now.


DISCLAIMER: Any posts on LJ are posted by individuals acting in their own right and do not necessarily reflect the views of LJ. LJ will not be held liable for the actions of any user.

Latest Projects | Latest Blog Entries | Latest Forum Topics

HomeRefurbers.com