LumberJocks

Reply by MiniMe

  • Advertise with us

Posted on What specialty screws or what else should I use to make this router table adjustable (height wise)

View MiniMe's profile

MiniMe

421 posts in 1020 days


#1 posted 11-08-2019 03:33 PM



What if you made your bracket threaded (fasten a nut to the bracket?) and forgo the t-nut? Also, move your lock nut to the bottom side as well.

Then, you can turn the big handle below the bracket to adjust height, and tighten the locknut from below as well.

- Axis39


Not enough meat in the bracket to thread it
Not sure how I can fasten that
I need the end of the screw to be attached to the router table body otherwise the board will move


The top nut must be fastened to the bracket in order to make the adjustment. If the bracket is thick enough you could tap some threads in it and eliminate the top nut and use the bottom nut to secure the adjustment. Welding or adhering the nut to the top of the bracket would also work.

See the above answer
Another method would be to cut a piece of plywood the size of the bracket bottom fasten it with screws to the bracket and install a T-Nut in it. Keep the bottom nut on the adjuster and tighten it after the adjustment is made.

- 4wood


this is what I am considering, run two traversal pieces of (ply)wood or metal and screw then to the brackets.
That will reinforce everything and keep them level with the opposite braket
Then do what you said like below


DISCLAIMER: Any posts on LJ are posted by individuals acting in their own right and do not necessarily reflect the views of LJ. LJ will not be held liable for the actions of any user.

Latest Projects | Latest Blog Entries | Latest Forum Topics

HomeRefurbers.com