LumberJocks

Reply by EugdOT

  • Advertise with us

Posted on Question about grizzly go555lanv bandsaw

View EugdOT's profile

EugdOT

332 posts in 1794 days


#1 posted 05-01-2019 01:33 AM

Thanks captain definitely a lot of good into. Earlier today i check everything all over again I think my problem is the vertical bar. I don’t think it’s flat and square throwing off the upper guide unit. The table is square to and level to the blade. Blade is square to the table on three sides. The problem is the right bearings due to the upper unit skewed To the left because when the top most set screw is tightened it doesn’t allow my right bearing to move away from the blade. I am going to try to reinstall the vertical arm tomorrow and file it flat. Hopefully that helps. But I definitely will be using your resources to help problem solve further


DISCLAIMER: Any posts on LJ are posted by individuals acting in their own right and do not necessarily reflect the views of LJ. LJ will not be held liable for the actions of any user.

Latest Projects | Latest Blog Entries | Latest Forum Topics

HomeRefurbers.com