LumberJocks

Reply by Rich

  • Advertise with us

Posted on Keeping glue joints aligned

View Rich's profile

Rich

5608 posts in 1360 days


#1 posted 04-11-2019 09:46 PM


You can also shoot three or four 23 ga pins that are shorter than the thickness of the board into one face and clip them with diagonal cutters.

- Rich

I’m sure it’s obvious that if the pins go in flush with the board, the above trick is worthless. One good way to make sure the pins stand proud of the surface is to shoot them through a thin board, maybe 1/8” to 1/16”, laying on top of the board you want to glue. The thin board will lift off of the pins easily and there will be enough pin protruding to snip like described above.

-- Half of what we read or hear about finishing is right. We just don’t know which half! — Bob Flexner


DISCLAIMER: Any posts on LJ are posted by individuals acting in their own right and do not necessarily reflect the views of LJ. LJ will not be held liable for the actions of any user.

Latest Projects | Latest Blog Entries | Latest Forum Topics

HomeRefurbers.com