LumberJocks

Reply by Jason Lester

  • Advertise with us

Posted on 15" Buffalo Planer

View Jason Lester's profile

Jason Lester

47 posts in 1104 days


#1 posted 03-12-2019 04:06 PM

Parts came in today.

At first glance the springs may be a touch bigger than the ones needed for my plane but I believe I can get them to work. They should just stay captive this way.

The blade setting jig should work nice once the springs are installed. I’ll double check the measurements to make sure it sets them near the right height.

The table roller is nice too. But now I have to figure out how to install it. I was hoping it would fit through the top of the table but it doesn’t look that way. It looks like I have to take the top off the base and separate the bottom etc… Was hoping not to have to do that yet. May be getting into the full clean up sooner than I expected.

So I now believe I have all the parts, minus the in and out-feed table bolts I have to replace due to them lifting with that.

Sure hope its worth all the effort once I am done. I am sure it will but I always have that doubt

-- Jason


DISCLAIMER: Any posts on LJ are posted by individuals acting in their own right and do not necessarily reflect the views of LJ. LJ will not be held liable for the actions of any user.

Latest Projects | Latest Blog Entries | Latest Forum Topics

HomeRefurbers.com