Reply by SenecaWoodArt

  • Advertise with us

Posted on Update on 2 mini laser engravers after 2 weeks of use

View SenecaWoodArt's profile


446 posts in 2222 days

#1 posted 01-18-2019 09:51 PM

Cool. What laser are you using? Does this work with these mini lasers? It says it is Grbl based and the boards in these are not quite at that level without changing out the board and laser as far as I can tell. I remember looking at Grbl based stuff a few weeks ago and concluding it wasn t an option. If it is, that would be great. This video is on youtube= about how to upgrade a mini laser s hardware but it was a pretty tedious job as the controller boards in these aren t arduino/grbl based. (whatever that means).

- Andybb

I have to admit that I don’t have any experience with the mini lasers and you obviously have done some research into it. I am using a 2500MW A3 laser. The software that I replaced was Benbox and that one was complete junk. But what do you expect for free. T2Laser opened up a whole new world for me and $40 is dirt cheap for laser software.

-- Bob

DISCLAIMER: Any posts on LJ are posted by individuals acting in their own right and do not necessarily reflect the views of LJ. LJ will not be held liable for the actions of any user.

Latest Projects | Latest Blog Entries | Latest Forum Topics