Reply by username

  • Advertise with us

Posted on Powermatic 66 table saw 5hp 1 phase On/Off

View username's profile


12 posts in 437 days

#1 posted 01-14-2019 11:50 PM

I found the correct Baldor wiring diagram, this confirmed I had replaced & reconnected the capacitors correctly.

Using the wiring diagram, it was obvious that the manual reset button was bad. A new switch is on order. FYI, the button was not popped out.

When I opened up the motor I noticed the centrifugal switch had previous damage and had been repaired (w/ super glue), so I ordered a new one.

Opening up this motor & doing some basic wiring checks was a good learning experience. I am very surprised just how simple these motors are.

DISCLAIMER: Any posts on LJ are posted by individuals acting in their own right and do not necessarily reflect the views of LJ. LJ will not be held liable for the actions of any user.

Latest Projects | Latest Blog Entries | Latest Forum Topics