LumberJocks

Reply by bgilb

  • Advertise with us

Posted on Wood drifts away from table saw fence at end

View bgilb's profile

bgilb

101 posts in 3671 days


#1 posted 12-19-2018 05:22 AM

Yes it’s the same with the riving knife. I haven’t tried another blade. Tonight I played with the fence a lot basically reset everything and using finish washers to allow some adjustability while tightening the aluminum fence down I managed to get it about within .001 all around as far as bumps and rises.

This led to about a .005 error over an 8” rip in the wood. Is that within acceptable? That’s about 1mm over 80 inches unless my math is off


DISCLAIMER: Any posts on LJ are posted by individuals acting in their own right and do not necessarily reflect the views of LJ. LJ will not be held liable for the actions of any user.

Latest Projects | Latest Blog Entries | Latest Forum Topics

HomeRefurbers.com