LumberJocks

Reply by therealSteveN

  • Advertise with us

Posted on 12 Inch Miter Saw Blade Advice

View therealSteveN's profile

therealSteveN

4075 posts in 1109 days


#1 posted 12-01-2018 06:01 AM


I run a 90 tooth blade for fine cutting. But for dead nuts miter cuts I use a 45* sled on the TS.

- ChefHDAN

Same here. For the fine cuts I use a sled on the TS with a high count crosscut blade. I use an 80 tooth Hi ATB made just for TS crosscuts. The one currently is a Ridge carbide blade

On the miter saw I use a very nice blade, but usually save the money for the TS blade for the sled. The crosscuts can be ok, or even a little rough. Right now I have this Freud on my 12 inch chopper I picked that one because I had a job where I was cutting 8” wide pieces of plywood to length, and I didn’t want it to fray up at the cut lines. It does a great job on solid woods as well, so if you will it’s a “combo” blade for all materials on a chopper. If it wasn’t for the plywood I had planned I would have bought a lower priced blade for the chopper. I’ve found when sharp even medium quality blades work ok for non finish cuts on a chopper.

-- Think safe, be safe


DISCLAIMER: Any posts on LJ are posted by individuals acting in their own right and do not necessarily reflect the views of LJ. LJ will not be held liable for the actions of any user.

Latest Projects | Latest Blog Entries | Latest Forum Topics

HomeRefurbers.com