Reply by woodbutcherbynight

  • Advertise with us

Posted on combination outfeed table, assembly table, work bench

View woodbutcherbynight's profile


5975 posts in 2973 days

#1 posted 11-29-2018 03:04 AM

Looks like a good concept drawing. What do you plan to put in each drawer? I spent quite a bit of time planning on what went into the drawers to determine drawer height and width. As an example this drawer was set to hold 3 saws and sawblades for the tablesaw and circular saws. The circular saws sit upright with a box that has a opening to allow the blade and guard to go below but not touch bottom of drawer. Each drawer was set the same way. Some would say this is over thinking or overogranizing. Possibly, but with them laid out in this manner I was able to jam alot more tools than if I had just used say 4 inch drawers and worried about what went where later.

-- Live to tell the stories, they sound better that way.

DISCLAIMER: Any posts on LJ are posted by individuals acting in their own right and do not necessarily reflect the views of LJ. LJ will not be held liable for the actions of any user.

Latest Projects | Latest Blog Entries | Latest Forum Topics