Posted on Drill Press drum sander
#1 posted 11-26-2018 03:45 PM |
I’m with BurlyBob. I’ve been very happy with the Wen OSS. Prior to picking up the OSS, I used sanding drums in my drill press successfully. Long-term it could cause bearing failure as WoodenDreams points out above. Also, if you put too much pressure on the drum, it can loosen the taper fit of the shaft in the spindle and cause your chuck to fall out. -- I collect hobbies. There is no sense in limiting yourself (Don W) - - - - - - - - Kenny in SW VA |