LumberJocks

Reply by eflanders

  • Advertise with us

Posted on TS cutting on when i pull back the miter gauge

View eflanders's profile

eflanders

329 posts in 2768 days


#1 posted 02-14-2018 11:02 PM

Sounds to me like an alignment issue. Things to check are: 1). My Inca jig came with plastic washers to maintain a good fit into the miter gauge slot. Is your gauge showing any side to side slop in the miter gauge slot? 2). Have you checked the blade for alignment to the miter gauge slot? A dial caliper is usually used for this but you can get very close with an accurate tape or by simply clamping a board to the miter guage. 3). Is your miter guage square to the table? This is the very first step in setting up your miter gauge. 4). Does your blade have some warp or wobble to it? This is somewhat rare but it does happen. Try another blade and see if it does the same thing. Good luck!


DISCLAIMER: Any posts on LJ are posted by individuals acting in their own right and do not necessarily reflect the views of LJ. LJ will not be held liable for the actions of any user.

Latest Projects | Latest Blog Entries | Latest Forum Topics

HomeRefurbers.com