LumberJocks

Reply by LesB

  • Advertise with us

Posted on Making elk antler lamp

View LesB's profile

LesB

2093 posts in 3837 days


#1 posted 02-05-2018 05:56 PM

You can buy long shaft drill bits if the length of you bits is the problem.

At sharp bends you might have to start a new crossing hole from the outside and plug it when you have the wire installed, so save the drill material so you can mix it with epoxy or thick superglue fo the patch. Of if you have spare material you could cut a plug for the hole.

I would think if you cut the antler some sort of reinforcement at the glue joint will be needed. Maybe a metal tube or if the point of the cut is wide enough you can drill a couple of smaller holes to put reinforcing metal pins in.

-- Les B, Oregon


DISCLAIMER: Any posts on LJ are posted by individuals acting in their own right and do not necessarily reflect the views of LJ. LJ will not be held liable for the actions of any user.

Latest Projects | Latest Blog Entries | Latest Forum Topics

HomeRefurbers.com