LumberJocks

Reply by Tenfingers58

  • Advertise with us

Posted on Zero Clearance Insert

View Tenfingers58's profile

Tenfingers58

96 posts in 3278 days


#1 posted 05-30-2012 06:01 PM

Measure how far below the table surface the 10” blade sits. I would then put in the dado blade and raise it to just above that spot. Then lower it all the way down counting the number of times I turned the crank. After clamping a board down to hold the insert, turn on the saw, raise the dado blade the same number of turns to cut the bottom of the insert to make room for the 10” blade. Install the 10” blade you will be using with the insert, reclamp the insert and cut through.


DISCLAIMER: Any posts on LJ are posted by individuals acting in their own right and do not necessarily reflect the views of LJ. LJ will not be held liable for the actions of any user.

Latest Projects | Latest Blog Entries | Latest Forum Topics

HomeRefurbers.com