Reply by bbasiaga

  • Advertise with us

Posted on SawStop dado set recommendations

View bbasiaga's profile


1243 posts in 2389 days

#1 posted 01-31-2018 02:54 PM

I usually measure the board that will go in the dado with a caliper, then figure out the chipper and shim combo that gets closest. Usually one or two test cuts and I an good to go.


-- Part of engineering is to know when to put your calculator down and pick up your tools.

DISCLAIMER: Any posts on LJ are posted by individuals acting in their own right and do not necessarily reflect the views of LJ. LJ will not be held liable for the actions of any user.

Latest Projects | Latest Blog Entries | Latest Forum Topics