LumberJocks

Reply by Ron

  • Advertise with us

Posted on Advice on building cabinets accurately in a small shop

View Ron's profile

Ron

1 post in 572 days


#1 posted 01-28-2018 12:51 PM

In addition to the above comments I would suggest checking your crosscut sled using the 5 cut method. There are numerous youtube videos showing how to do this. I also break down sheet goods like you do but I check the sheet for squareness and if it’s square you know you have 90 degree corners. I don’t use a sled, just the fence on the table saw. I use the factory edges as my starting point and after every cut I put an X on the side so I know later that it is a “good” edge. Also when there are several pieces that are the same height and width I will cut them all to the required width from one fence setting and then to length from one fence setting. Good Luck with you project.

-- Ron


DISCLAIMER: Any posts on LJ are posted by individuals acting in their own right and do not necessarily reflect the views of LJ. LJ will not be held liable for the actions of any user.

Latest Projects | Latest Blog Entries | Latest Forum Topics

HomeRefurbers.com