Reply by dhazelton

  • Advertise with us

Posted on Old Craftsman Jointer question

View dhazelton's profile


2839 posts in 2774 days

#1 posted 01-16-2018 03:52 PM

I would drill a small hole in a thin piece of plywood and put that over the pin, then grab the pin with vise grips and just start wriggling it out. Since you’ll never joint a board wider than 6 inches it isn’t really needed. And when you do want to go wider than 6 you’re going to pull the porkchop off anyway.

DISCLAIMER: Any posts on LJ are posted by individuals acting in their own right and do not necessarily reflect the views of LJ. LJ will not be held liable for the actions of any user.

Latest Projects | Latest Blog Entries | Latest Forum Topics