LumberJocks

Reply by Kazooman

  • Advertise with us

Posted on Router Table - Direction of Feed

View Kazooman's profile

Kazooman

1540 posts in 2840 days


#1 posted 01-15-2018 09:18 PM

Seems like a strange way to go about this. If the side of the box is to the left of the bearing as you are facing then I believe it would be the same as if you were using the fence. You would push away from you feeding the stock into the rotating cutter. Think about it. The bearing is just a very short (and round) fence.

Note that the slots will not reach into the corners. You are going to have a ton of hand work facing you to finish them off to hold the bottom panel. With a decent sized slot cutter the bearing would be pretty big to give a shallow slot. That will keep you well out of the corners for sure.

The stopped cuts are a snap if you just set up starting and ending blocks on the fence.


DISCLAIMER: Any posts on LJ are posted by individuals acting in their own right and do not necessarily reflect the views of LJ. LJ will not be held liable for the actions of any user.

Latest Projects | Latest Blog Entries | Latest Forum Topics

HomeRefurbers.com