LumberJocks

Reply by JBrow

  • Advertise with us

Posted on Breadboard tenon length on large breadboards

View JBrow's profile

JBrow

1368 posts in 1250 days


#1 posted 12-31-2017 03:00 AM

AJacob,

I am a long way from being an expert on breadboards so I am not sure why the rule of thumb you cited exists. Absent this understanding, I agree that a 2-1/2” long tenon seems short for a 10” wide breadboard. But if the breadboard remains flat over time, 2-1/2” long tenons may be sufficient. My only concern is that tenons too short might cause the breadboard connection to fail should someone sit on the breadboard. I cannot say whether this is a real or imaginary concern.

The only problems I can foresee with longer tenons is chopping well-fitting deep mortises would be more difficult. Also a 10” wide board with long tenons that are pinned too far away from the table top/breadboard joint could cause the breadboard to crack. If pinned close to the table top/breadboard joint, then the breadboard could still expand and contract.

I assume there is a good reason for such a wide breadboard. If reducing its width is not practical, then ensuring the breadboard is quartersawn could at least reduce or eliminate cupping of the wide breadboard. I doubt that longer tenons could resist the forces associated with a cupping breadboard.


DISCLAIMER: Any posts on LJ are posted by individuals acting in their own right and do not necessarily reflect the views of LJ. LJ will not be held liable for the actions of any user.

Latest Projects | Latest Blog Entries | Latest Forum Topics

HomeRefurbers.com