LumberJocks

Reply by wts

  • Advertise with us

Posted on What flatness tolerance can be achieved over a large surface with hand planes?

View wts's profile

wts

3 posts in 650 days


#1 posted 12-05-2017 02:18 PM

Thanks Smitty and Matt! This helps puts the flatness requirement into perspective, and maybe I should just call it good. However, my concern is that I may run into problems clamping work pieces along the outer perimeter of the bench (I cannot reach clamps to the center of the bench of course). Anything wider than 6” that I clamp down along the edges will inherently have a fairly significant amount of mismatch. I think that it may even be closer to 0.10” flatness (+/- 0.05”) in a few places relative to the center actually.

Perhaps I am overthinking it? :P


DISCLAIMER: Any posts on LJ are posted by individuals acting in their own right and do not necessarily reflect the views of LJ. LJ will not be held liable for the actions of any user.

Latest Projects | Latest Blog Entries | Latest Forum Topics

HomeRefurbers.com