LumberJocks

Reply by Kazooman

  • Advertise with us

Posted on Pulling Jigs

View Kazooman's profile

Kazooman

1540 posts in 2833 days


#1 posted 11-09-2017 09:59 PM

Not the most elaborate, for certain, but it was for a one off job. This is the only piece that remains.

Pieces and strips of plywood glued to a hardboard base. The other piece of the jig was a sled that firmly held a 6 1/2” x 14” piece of maple. The slotted jig was screwed in place and then the slots were used with a router fitted with a straight bit and a guide bushing to cut the maple stock. Flip the work piece end for end and repeat. The top edges of the piece were given a wide gentle chamfer on the table saw and the underside was trimmed to fit an opening. A floor heating vent cover to go with the new maple flooring we had installed. Much nicer look than the crappy metal ones I could find. I’ll probably never use the jig again, but the time to make it was worth it.


DISCLAIMER: Any posts on LJ are posted by individuals acting in their own right and do not necessarily reflect the views of LJ. LJ will not be held liable for the actions of any user.

Latest Projects | Latest Blog Entries | Latest Forum Topics

HomeRefurbers.com