LumberJocks

Reply by sciotomike

  • Advertise with us

Posted on Delta Jointer

View sciotomike's profile

sciotomike

12 posts in 616 days


#1 posted 10-10-2017 01:17 PM

This may not be a math problem (calculating RPM), it may be a knife setting problem.

The RPM calculations above are correct, however the effectiveness of the joiner is determined by CPM (cuts per minute). If one knife is set higher than the other two, your CPM have been reduced by 1/3. Thus leaving a wavy finish.

Feed rate can also be an issue (too fast), but not likely.


DISCLAIMER: Any posts on LJ are posted by individuals acting in their own right and do not necessarily reflect the views of LJ. LJ will not be held liable for the actions of any user.

Latest Projects | Latest Blog Entries | Latest Forum Topics

HomeRefurbers.com