LumberJocks

Reply by Loren

  • Advertise with us

Posted on Flattening Rough Board with only Low Angle Jack?

View Loren's profile

Loren

10477 posts in 4159 days


#1 posted 10-06-2017 05:17 PM

I would roughly plane both faces and mark
them with a yellow or white pencil to indicate
which direction planing produced a smoother
surface. Chalk works too.

From there you can rip some rough edges and
clamp them up to see if they’re going to go
together flat enough to make one panel to
cut your parts from. If not, you may have
to remove some twist from one or more.
Of course the glue joints will come out nicer
if you hand plane them.


DISCLAIMER: Any posts on LJ are posted by individuals acting in their own right and do not necessarily reflect the views of LJ. LJ will not be held liable for the actions of any user.

Latest Projects | Latest Blog Entries | Latest Forum Topics

HomeRefurbers.com